Factors Affecting The Auto Parts Balancing Machines?

Auto Parts Balancing Machines is a kind of balance measurement instrument, but also can appear some problems in the work, small make up just like you said balancing machine affect auto parts under normal work what are the factors.

The workpiece of the Auto Parts Balancing Machines is not good in the shaft neck, causing the car parts balance machine to not work properly.

2. The stiffness of the workpiece of the Auto Parts Balancing Machines is not good and easy to be damaged.

3. The surface roughness of the workpiece itself is too low.

At present, with the use of microcomputer technology, dynamic balancing machine and auto parts into a new era, dynamic balancing machine auto parts in terms of performance, accuracy and operability are improved significantly. Dynamic Auto Parts Balancing Machines has been widely used by people, even better, but will inevitably fall on the dust, not only look not beautiful, also affect the mechanical properties, therefore, there is a lot of people will ask, how to make dynamic balancing machine auto parts cleaning job?

Always keep the Auto Parts Balancing Machines clean, the guide surface should be kept clean, and the oil and rust should be applied regularly. The supporting block or roller surface should be kept clean. No iron filings and debris shall be adhered to. The net supporting block or roller and rotor shaft neck shall be wiped out before each work, and a little lubricating oil shall be added. Mobile support should be at the same time when the rotor rotation or move around supporting frame with speed at the same time, in order to avoid the shaft neck and roller surface scratches and wear, will never allow the rotor to knock on roller shelf or impact. An unbalanced rotor creates a pressure on its supporting structure and the rotor itself during its rotation and causes vibration. Therefore, the dynamic balance of the rotor is very necessary.

1. Maintain the connection part of the surface to keep clean, check carefully before work, and lubricate well in the work.

2. All parts of the pendulum have been adjusted before leaving the factory, and do not disassemble in use.

3. Add a proper amount of 30 engine oil to each shift, and the butter should be cleaned and changed once a year under the system.

4. The locking mechanism should be able to securely lock the frame and release it when it is released. The swing part should be completely removed, and the frame will only release during measurement. The rest of the time should be locked tightly and the wheel should not be moved when the lock is tight.

5. Non-working time frames should not be placed in balanced parts.

6. Electrical boxes should be kept clean to prevent dampness.

7. When the machine is found to be unable to handle during use, it should cut off the power in time and notify the maintenance team.

Dynamic auto parts photoelectric head shots of the Auto Parts Balancing Machines should be used to clean the mirror glass paper or the outer surface of the clean cloth to wipe clean the mirror lens, keep clean, never use yarn with oil or wiping the dirty cloth mirror. The Auto Parts Balancing Machines is a sophisticated testing equipment, which should be kept and operated by a special person.