.png)
.png)
.png)
Install
The balancer must be installed on a firm foundation, and it needs to be fastened with expansion screws or embedded screws (the level can be adjusted with rigid materials such as adjusting horns, and it is strictly prohibited to pad rubber, wood, paper and other soft materials under the base)
The balancer must be installed on a firm foundation, and it needs to be fastened with expansion screws or embedded screws (the level can be adjusted with rigid materials such as adjusting horns, and it is strictly prohibited to pad rubber, wood, paper and other soft materials under the base)
The automatic balance machine must be grounded reliably, and the grounding resistance must be less than 4 ohms
Safety
Operators must undergo pre-job training and can operate the equipment after passing the assessment
The speed and load of the machine are selected according to the specified parameters
When working, the operator should stand on the side to prevent the rotating workpiece from hanging
When parking, it is strictly forbidden to stop the rotor with hand brake
During the balancing operation, if the balance of the rotor is unknown, the unbalanced amount should be measured at the lowest speed that can be measured first, and then the higher speed is used to check
Power must be cut off after work
Use
After adjusting the swing frame and the drive frame, all adjustment screws must be tightened
Check the support piece or roller, if there is serious wear, it must be replaced in time
Check the belt, if it is worn, aging, or cracked, it must be replaced in time
The workpiece should be placed on the balancer carefully and steadily, and the supporting part must be wiped clean to avoid measurement errors
The guards on both sides of the bed and the upper pressure frame should be fixed
During operation, the rollers, supporting pieces and other parts need to be filled with lubricating oil frequently to maintain lubrication
Maintenance
The equipment must be kept clean, and the rail surface must be frequently oiled to avoid rust
Since the machine has a battery retention circuit, when the machine is not in use, the battery should be charged for a few hours after turning on the machine every 1 to 2 months to prevent the battery from running out and causing data loss.
In humid areas and weather, the equipment should be energized frequently to dissipate moisture.
