Armature Two Station Automatic Balancing Machine

Nowadays, many machines use wound armature. According to the demand of the market, Shanghai Jianping has developed a wound armature automatic balancing machine, which carries out stepless speed regulation in the rotor working speed range; In addition to measuring the vibration or vibration force of the support and correction, it can also measure the deflection deformation of the rotor. Now let me introduce the wound armature automatic balancing machine for you.

Which fields does the wound armature automatic balancing machine apply?

Automobile starter rotor, electric tool rotor, small household appliance rotor and wiper rotor etcV-cutter is used for silicon steel sheet, width is about 6-8mm

R-cutter milling amount is large, cycle time is short

Now let's look at the mechanical parts of the machine

Measuring unit: soft-bearing structure + drive unit

Rotary arm: directly connected and split type to adjust the center height, the gripper will not fall off

Processing & weight removal unit:

The two-axis automatic machine can mill two faces in an non-stop state, with less interference and high efficiency.

The single-axis automatic machine can only do single-plane balancing because the rotor is short.

So what are the software parameter settings?

Balancing speed

Radius

Allowable amount

Silicon steel sheet density

Number of slots to be machined and their depth

Center of mass

For our machine, are there any installation requirements?

1: Keep away from the vibration source

2: The foundation needs to be stable

3: Key parts need to be lubricated

4: Clean table surface regularly

You might also want to know what are the optional functions?

Safety light curtain

Siemens motors

15 inch display

Brand vacuum cleaner

For machine acceptance, what tests are required?

Don't worry, our machines go through strict factory testing.

MSA: 10 rotors, 3 men to test

CPK: Repeated Reproducibility Test, 50 groups, 125 groups start and stop, need to remove and put back the rotor and repeat test

CGK: 50 groups/125 groups, start and stop, repeat test

Automatic balancing machine is to pre-set N programs for the whole process of rotor correction (initial test - remove weight - retest), and select one of the programs during rotor correction, turn on the power and start the balance machine switch, the whole process of rotor correction will be automatically completed. Through the unbalance calculation of initial test and match with the weight removal unit for correction and retest, thus the achieve automatic control is achieved.

The balancing machine is characterized by short correction time, two stations used together, high work efficiency, because the two stations are compatible with each other, the correction ratio is high, and it is a horizontal bearing pedestal design, the use is relatively simple. This balancing machine is suitable for rotor dynamic unbalance correction of small varieties and large batches. Welcome to contact us to learn about the latest wound armature automatic balancing machine!